ODE先導活塞式電磁閥安裝注意事項[產品打印頁面]

ODE先導活塞式電磁閥安裝注意事項
When the coil is energized, the plunger moves, the gasket is mounted thereon,
 so that the guide hole opens and discharges the chamber above the diaphragm:
Unbalanced pressure to open the diaphragm of the main hole.
In this group of solenoid valves must have a minimum value between
the inlet pipe and the outlet pipe to ensure that the
pressure between the normal operation of the solenoid valve.
所以如果這個壓差是大于螺線管的值閥門已經設計，
usually with the same 2 closed solenoid valve, with pilot control,
Install the normally open kit at the location of the open kit to open and close the guide hole.
So in this case when the coil is energized, the pilot hole is closed,
The diaphragm is thus positioned at the position of the closed body and the
pilot hole in which the coil is not energized is open, thereby causing the main bore to open.
后者可能不會重新打開當線圈不通電時。
However, the pressure difference between the entrance is too large
And the outlet, as is usually the direct effect of the solenoid valve 2,
resulting in the required force to open the pilot valve,
Two-way normally open solenoid valves with pilot control have inlet and outlet tubing.
With regard to the movement of these solenoid valves the function of the diaphragm,
為了正確操作電磁閥，并避免膜片的快速磨損，建議一次啟動閥關閉，
When the coil is not energized, there is pressure below the fluid chamber below the diaphragm
The diaphragm has the pressure only in the outer area of the main hole:
thus the force on the diaphragm forces to push it and close the main orifice.
實際流量不高于Kv（即：流量通過閥，壓力損失為1巴）。
因此，如果閥門打開時的入口壓力，高于1巴，就是不建議使用具有自由出口的閥本身，
Two-way normally closed solenoid valve with pilot control inlet pipe and outlet pipe.
The main hole in the body, through the unbalanced
pressure between the opening of the diaphragm (or piston) on the upper and lower surfaces:

ODE先導活塞式電磁閥安裝注意事項

產品留言

標題

聯系人

聯系電話

內容

驗證碼

點擊換一張

注：1.可以使用快捷鍵Alt+S或Ctrl+Enter發送信息!
2.如有必要,請您留下您的詳細聯系方式!